Extra 20% off at checkout · Use code SAVE20
CarCover.com
AccessoriesHeavy Duty Car Cover Wind Straps
Heavy Duty Car Cover Wind Straps

Heavy Duty Car Cover Wind Straps

SKU: GS
$19.77
$22.47
12% off
In stockFree shipping

Two bungee cords and four reinforced clips that hold your cover tight through storms and gusts.

Buy It Now
Free shipping
30-day risk-free returns
Storm-rated hold
Why drivers pick this cover

Your cover is not going anywhere

Wind is the one thing that beats a good cover: it lifts loose fabric, works it back and forth, and can pull the whole thing off overnight. These heavy-duty straps anchor your cover under the bumpers so it stays put through storms, gusts and winter weather.

Built for real wind. Designed to stop lifting and shifting on vehicles parked outside in windy, storm-prone areas.

Serious grip. Four reinforced nylon clips bite onto the cover’s edge, and high-tensile bungee cords pull it down snug.

On in under a minute. Clip, hook under the front and rear bumpers, done. No tools, no ladders, no help needed.

Fits any vehicle. The 55-inch cords (unstretched) reach under everything from sedans to full-size trucks and SUVs.

Trusted by pros. The same straps used by auto body shops, mechanics and collectors to protect fresh paint and detailing.

If your car sleeps outside, this is the cheapest insurance you can buy for your cover, and the paint under it.

What's in the box

4 solid clips
2 bungee cords, 56.69″ unstretched

How to use

1

Clip. Attach two clips to the cover’s edge near the front bumper and tighten until they can’t slip off.

2

Hook. Run a bungee cord under the bumper and hook it into the small hole on each clip.

3

Repeat at the rear. Do the same with the other cord and clips at the rear bumper.

4

Snug it up. Smooth out loose fabric so the wind has nothing to grab.

No tools, no help needed

Installing your heavy-duty wind straps

1–2 minutes1 person4 steps
1
Drape the first strap

Lay one strap across the cover about a third of the way back from the front, so it crosses the roofline and hangs evenly on both sides.

2
Pass it underneath

Slide or toss the buckle end under the vehicle to the other side. On a low car it helps to feed it through with the tail.

3
Clip and cinch

Click the buckle together at the side of the vehicle, on the fabric and never against paint, then pull the tail until the strap sits snug and the cover dimples slightly.

4
Repeat at the rear

Fit the second strap a third of the way forward from the rear, cinch it, then walk around once: no slack, no flapping edges.

Read this first
✕Straps go over the cover, never against bare paint
✕Keep the webbing clear of the exhaust: a hot tailpipe can melt it
✕Position buckles at the side of the vehicle, on fabric, not on a painted panel
✕Snug is right, crushing is not: over-tightening stresses the cover’s seams
✕Re-check tension after the first windy day and re-cinch if the strap has settled
✕Wind straps secure the cover, not the vehicle: never use them as transport tie-downs
Need help deciding?

A real person, in under a minute.

Fit questions, grade advice, order help, pick your channel.

Risk-free
Try it at home
30-day money back

Put it on your car for a full month, return it if it's not right.

Fastest→
Call us now
1-800-916-6041

Cover specialists pick up 9 AM to midnight ET, 7 days a week.